Love Home Design

Attaching Deck Stairs

55 sec read

Attaching Deck Stairs

Attaching Deck Stairs

Install a piece of blocking below the rim joist to extend the attachment surface for your stairs stringers. Use a level to mark the top step. Measure down from the top of the deck and mark the top of your stair stringers with a level.
Use structural screws instead of nails to mount the stringer hardware. Screws are less likely to withdraw from the rim joist or header over time. Stair treads must have a nose projection of between 3/4 inch and 1 1/4 inches beyond the riser face when the tread cuts are less than 11 inches deep.
Learn about attaching stairs to a deck using any of these common construction methods. Find out which method is best for the style of your deck.
Follow these steps for a safe set of wood deck stairs.. Check out How to Build a Deck: Post Holes and Framing for step-by-step instructions on setting posts.
Cut stair treads so that they overlap the stringers by about 1" on both sides. If the stair width is 36”, cut treads 38”. Push one tread against the back of the stringer, center, and fasten with two 3” galvanized deck screws per side. Leave 1/4” between the first and second tread board and attach with deck screws.
Sure, building deck stairs can be tricky. But in this. Begin this how to build stairs project by drawing a side view of your site and adding dimensions (Fig. A).
Jul 16, 2018- deck stair design Attaching to the top of a landing offers a similar. Attaching Deck Stringers To Rim Joist – Carpentry – DIY Chatroom Home .

Love Home Design

Leave a Reply

Your email address will not be published. Required fields are marked *